The rabbet is a groove cut into the side of the keel to accept the planking. I rough cut it using my Skillsaw and will chisel it out as needed.
Minggu, 12 Juni 2016
Langganan:
Posting Komentar (Atom)
Popular Posts
-
I have now installed the alarm system. Its a wireless setup which can take up to 16 sensors. Currenlty I have 4 door break sensors and 4 p... -
tango skiff boat plans This is my newly completed ...
-
Model plans for canal boat / narrowboat 1/24 by scalemodeldiy. (pic now the bow and the stern are ... -
1/4 jet sprint hull design (1000mm) attached are some pics with dimensions of a version of a jet s...
-
building a paddle wheel boat By p. a. baumeister. ...
-
Sailboat with stability and good performance. the oz goose is a 12ft sailboat with enormous stabil... -
18: tunnel mite – 10′ please note that these are not plans but building instructions only. click h...
-
These sets of plans will get you on your way to having your own mini jet boat.. Jet...
-
plywood hydroplane boat plans Learn how to build y...
-
A stepped scarph joint is the mechanically produced equivalent to a hand-planed sloping scarph joint. It is normally cut on a CNC router tha...
0 komentar:
Posting Komentar